11 36 590 Removing and installing/replacing solenoid valve of camshaft adjustment unit, right (M62 VANOS from 9/98)

WARNING: This page is about a different variant/trim than selected.

Remove intake filter housing with air-mass flow sensor.

Release screws on sealing flange.

Fig 1: Removing Camshaft Adjustment Unit Sealing Flange Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The sealing flange seals the timing case cover via the solenoid valve.

If necessary, clean solenoid valve with a cloth.

Remove sealing flange (1).

Fig 2: Removing Camshaft Adjustment Unit Sealing Flange

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Once it has been removed, oil drips from the solenoid valve.

Have a cleaning cloth ready.

Make sure no oil drips onto the belt drive. Remove any remnants of oil immediately with cleaning cloth.

Release solenoid valve with special tool 11 6 420.

Fig 3: Removing Camshaft Adjustment Unit Solenoid Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install solenoid valve (1).

Clean solenoid valve (1) and sealing face (2).

Fig 4: Installing Camshaft Adjustment Unit Solenoid Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Tighten down solenoid valve with special tool 11 6 420.

Tightening Torque,

Fig 5: Tightening Camshaft Adjustment Unit Solenoid Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check sealing flange (1), replace if necessary.

Apply a light coat of oil to inside of sealing flange (1) at sealing face to solenoid valve and carefully install.

Fig 6: Installing Camshaft Adjustment Unit Sealing Flange

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert screws on sealing flange and tighten down.

Fig 7: Inserting Camshaft Adjustment Unit Sealing Flange Screws

Courtesy of BMW OF NORTH AMERICA, INC.