11 53 000 Removing and installing/replacing coolant thermostat (M62)
WARNING: This page is about a different variant/trim than selected.
Remove upper section of suction filter housing with mass air flow sensor.
Unscrew and remove splash guard.
Drain off coolant and dispose of correctly.
Installation:
Vent cooling system and check for leaks,
refer to 17 00 005 DRAINING AND TOPPING UP COOLANT (M62) .
- Disconnect coolant hose.
- Disconnect plug-in connection.
- Remove thermostat housing cover with integrated thermostat.
Installation:
Replace sealing ring.