11 13 020 Removing and installing/replacing lower section of oil sump (M62)
WARNING: This page is about a different variant/trim than selected.
Open cover on main flow oil filter, engine oil returns to oil sump.
Remove reinforcement plate.
CAUTION:
The work step "Removing and installing reinforcement plate" contains important installation instructions, refer to 31 10 010 REMOVING AND INSTALLING REINFORCEMENT PLATE
.
Open oil drain plug. Drain engine oil.
Unfasten plug connection on oil level switch.
Unclip cable guide.
Release screws (1) and remove lower oil sump section.
Installation:
Clean sealing surfaces.
Replace seal.
Insert all screws (1) and tighten down.
Tightening torque,
refer to 11 13 2AZ in ENGINE - TIGHTENING TORQUES - X5 4.6L .