11 12 719 Milling down cylinder head gasketing face (M62)
WARNING: This page is about a different variant/trim than selected.
Cylinder head dismantled.
Check planeness of cylinder head gasketing face with straightedge (standard).
Deviation from planeness Max. 0.05 mm.
NOTE:
Machine limit, refer to 11 12 CYLINDER HEAD WITH COVER M62 B 46
in Technical Data.
CAUTION:
To compensate for compression, there is a repair cylinder head gasket.
NOTE:
The repair cylinder head gasket is designated at the back with a bore beside the 4th or 8th cylinder.