11 31 090 Installing and removing / replacing piston for chain tensioner (M62): Installation

WARNING: This page is about a different variant/trim than selected.

Replace sealing ring.

For tightening torque, refer to 11 31 7AZ in ENGINE - TIGHTENING TORQUES

Fig 1: Unfastening Screw Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Remove screw connection and piston for chain tensioner.

Fig 2: Removing Screw Connection And Piston For Chain Tensioner

Courtesy of BMW OF NORTH AMERICA, INC.

Arrangement of Components:

Tapered end of recoil spring (4) faces hydraulic piston (5).

Fig 3: Identifying Components Arrangement

Courtesy of BMW OF NORTH AMERICA, INC.

To simplify assembly, drain oil chamber between sleeve and hydraulic piston.

Fig 4: Draining Oil Chamber Between Sleeve And Hydraulic Piston

Courtesy of BMW OF NORTH AMERICA, INC.