17 11 370 Removing and installing/replacing cooling loop for power steering
CAUTION:
Make sure all parts are absolutely clean. No dirt is allowed to enter the system. After installation, bleed power steering. Refer to BLEEDING POWER STEERING SYSTEM
.
Recycling:
Draw off power steering fluid from supply tank - do not reuse fluid.
Observe country-specific waste-disposal regulations.
Disconnect quick-release couplings on hydraulic lines. Refer toHYDRAULIC LINE WITH QUICK-RELEASE COUPLING .
Remove radiator. Refer to 17 11 000 REMOVING AND INSTALLING RADIATOR (M62, M54 AND M57) .
Remove cooling coil.