LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2003 >> X5 30i, Automatic >> Repair and Diagnosis >> Electrical >> Gauges >> Body Equipment - Repair Instructions - X5 (3.0L) >> Trim, Covers, Handle Trim >> 51 13 402 Removing and installing handle strip (on trunk lid)

51 13 402 Removing and installing handle strip (on trunk lid)

Difference between versions before and after 09/01:

  1. A: Version before 09/01.
  2. 1. Wide seal over entire handle strip.
  3. 2. Open microswitch.
  4. 3. Plug connection.
  5. B: Version after 09/01.
  6. 4. Narrow seal only at top over entire handle strip.
  7. 5. Plug connection.
  8. 6. Small seal around plug connection (5).

Installation: 

In version (B), closed expansion nuts and shorter screws (3.5 x 13 mm) must be used.

Fig 1: Identifying Different Handle Strip Versions
G03255648Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and withdraw handle strip (2) somewhat.

Fig 2: Locating Handle Strip Screws
G03255649Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove handle strip (2).

Fig 3: Identifying Plug Connection
G03255650Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Seal(s) of handle strip (2) must not be damaged.

Tightening torque, (2.5 N.m.).

Perform function check with trunk lid open.

scientia non olet · About LEMON Manuals