26 11 090 Removing and installing/replacing centering mount for propeller shaft

NOTE:

For Special Tool identification, see SPECIAL TOOLS - X5 .

Special Tools Required:

Necessary Preliminary Tasks:

Fill centering bore (1) completely with viscous grease.

Drive special tool 11 1 310 with a plastic hammer into centering bore.

The centering mount (1) is forced out of the propeller shaft by the pressure on the grease filling.

If necessary, top up grease repeatedly.

NOTE: To drive out the mount, you can also fill the centering bore with water instead of grease.

Fig 1: Installing Special Tool Into Centering Bore

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Remove grease/water from mount bore.

Drive in centering (1) with special tools 11 2 030 and 00 5 500 into propeller shaft (observe protrusion).

Grease centering mount.

Fig 2: Installing Centering Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Observe protrusion A = 4⁺² mm of centering (1).

Fig 3: Identifying Protrusion Of Centering

Courtesy of BMW OF NORTH AMERICA, INC.