35 31 000 removing and installing/replacing clutch pedal

Remove panel and reinforcement plate.

NOTE: Check function after installation.

Remove clips (1).

Release screws (2) and press out retaining pin for clutch master cylinder.

Fig 1: Removing Clutch Master Cylinder

Courtesy of BMW OF NORTH AMERICA, INC.

CAUTION: Do not detach pressure line from clutch master cylinder.

Set down clutch master cylinder in footwell.

Detach retainer (3) for over-center helper spring.

Detach clutch pedal (1) in direction of arrow.

Fig 2: Detaching Clutch Pedal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check bearing bushes (1) and replace if necessary.

Apply light coat of grease to bearing bushes (1) and bore (2), refer to BMW SERVICE OPERATING FLUIDS .

Fig 3: Checking Bearing Bushes

Courtesy of BMW OF NORTH AMERICA, INC.