51 43 251 Removing And Installing/Replacing Trim For Rear Left Or Right Roof Pillar (Rear)

WARNING: Version with head airbag: Follow safety instructions for working on cars with airbag systems. Refer to 72 00... SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Version With Head Airbag In Rear Compartment:

If necessary, lever out airbag emblem (1) and release screw underneath.

Tightening torque, refer to 51 43 1AZ in BODY EQUIPMENT - TIGHTENING TORQUES .

Release clips (2) and catches (4) from trim (3).

Pull out trim (3) towards inside at top.

Fig 1: Locating Trim Clips And Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace defective grommets (1).

Fig 2: Locating Grommets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retainer (1) on trim (2) must not be damaged or missing.

Fig 3: View Of Trim Retainer

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clips (1) of panel (3).

Catches (2) on trim (3) must not be damaged.

Fig 4: Identifying Clips And Catches Of Panel

Courtesy of BMW OF NORTH AMERICA, INC.