63 21 186 Removing And Installing/Replacing Rear Light (On Center Of Rear Lid)
Lever out covers (1) at bottom and remove.
NOTE:
Releasing rear light is shown on left side.
Releasing rear light on right side is done in same way.
Unfasten plug connection (1) and disconnect.
Unscrew nuts (2).
NOTE:
Secure rear light against falling out.
Lower luggage compartment lid.
NOTE:
If necessary, secure shims under rear light (1) against falling out.
Pull out rear light (1) slightly in direction of arrow.
Disconnect plug connection underneath and remove rear light (1).
Installation:
Make sure gap is uniform all round between rear light (1) and luggage compartment lid (2).
Make sure sealing frame for rear light is correctly seated; replace if necessary. Refer to 63 21 107 REPLACING SEALING FRAME FOR REAR LIGHT (ON CENTER OF REAR LID) .
WARNING:
Follow instructions for handling light bulbs (exterior lights). Refer to 63 99 ... INSTRUCTIONS FOR HANDLING LIGHT BULBS (EXTERIOR LIGHTS) .
Replacement:
- If necessary, remove bulbs.