63 21 183 Removing And Installing/Replacing Left Or Right Rear Light (From 03/2005) (On Rear Lid)

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). Refer to 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary Preliminary Tasks:

Detach trim (1) in area (A) of rear light (2) downwards. Area (B) of trim (1) remains on vehicle.

Installation:

Ensure trim (1) is correctly seated.

Fig 1: Rear Center Trim, Area A, Area B And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect connector (1).

Unscrew nuts (2).

NOTE: Secure rear light against falling out.

Fig 2: Rear Light Plug Connection And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip rear light (1) and remove.

Installation:

If necessary, replace faulty clip (2).

Make sure there is a uniform gap (outer) all round for rear lid.

Make sure sealing frame for rear light is correctly seated;

replace if necessary.

Fig 3: Rear Light And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

WARNING: Follow instructions for handling light bulbs (exterior lights). Refer to 63 99 ... INSTRUCTIONS FOR HANDLING LIGHT BULBS (EXTERIOR LIGHTS) .

Replacement: