51 47 491 Removing And Installing/Replacing Rear Underbody Protection

Underbody Protection, Petrol/Gasoline Engines

Release screws (1).

Remove underbody protection (2) towards rear.

Installation:

Center underbody protection (2) and tighten down screws (1).

Fig 1: Identifying Screws For Underbody Protection

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1).

Remove heat shield (2).

Fig 2: View Of Heat Shield And Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Underbody Protection, Diesel Engines:

Release screws (1 to 3).

Remove underbody protection (4) towards rear.

Installation:

Center underbody protection (4) and tighten down screws (1 to 3).

Fig 3: Locating Underbody Protection Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.