51 14 008 Replacing (Removing And Installing) Number/Letter Combination On Front Left Or Right Side Panel

IMPORTANT: The "Instructions for number/letter combination cementing" serve as the basis for these repair instructions and must be followed without fail. Refer to 51 14... INSTRUCTIONS FOR ATTACHING NUMBER/LETTER DESIGNATION COMBINATION .

NOTE: Procedure is also mandatory for right side, outer edge of number is then positioned.

NOTE: Number/letter combination is stuck on at a height level with turn indicator (1).

Stick on adhesive tape (2) horizontally above turn indicator (1).

Mark measurement "A" of turn indicator (1).

Remove liner (protective strip for adhesive surface).

Position number/letter combination up against adhesive tape (2) and at measurement "A" and press down firmly.

Remove carrier film.

Fig 1: Identifying Measurement A

Courtesy of BMW OF NORTH AMERICA, INC.