35 11 000 Removing and installing mounting block for pedals

IMPORTANT: Check the function after installation.

Release screw (1) on footwell air duct. First pull footwell air duct to left, then remove towards bottom front.

Fig 1: Removing Footwell Air Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Detach retaining clip on brake pedal (1).

Fig 2: Detaching Retaining Clip On Brake Pedal

Courtesy of BMW OF NORTH AMERICA, INC.

Withdraw pin.

Release nuts (2).

Installation:

Replace nuts (2).

Tightening torque, 35 11 1AZ. Refer to PEDALS - TIGHTENING TORQUES .

Remove brake light switch (1). Refer to 61 31 310 REPLACING BRAKE LIGHT SWITCH .

Release nut (2) for brake pedal.

Fig 3: Releasing Nut For Brake Pedal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace nut (2).

Tightening torque, 35 11 1AZ. Refer to PEDALS - TIGHTENING TORQUES .

Unfasten screws (1).

Fig 4: Removing Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out light module with holder towards front.

Pull off connectors.

Remove light module.

Remove bearing bracket for pedal assembly.

Installation:

Position guide lug (1) precisely during installation to prevent damage.

Fig 5: Positioning Guide Lug

Courtesy of BMW OF NORTH AMERICA, INC.