51 24... Removing and installing/replacing angle transmitter for rear lid actuation (electrohydraulic-fully automatic)
Necessary preliminary tasks:
- Remove right luggage compartment wheel arch trim, refer to 51 47 161 REMOVING AND INSTALLING / REPLACING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM
- Remove panel for rear window shelf, refer to 51 46 000 REMOVING AND INSTALLING/REPLACING TRIM FOR REAR PARCEL SHELF
Lever out cable holder (1).
Lever out cover (2) and remove.
(3) Luggage compartment lid
Release screw (1).
NOTE:
Before nuts (3) are released, a 2nd person must open rear lid and hold angle transmitter (2).
Unscrew nuts (3).
Tightening torque 51 24 7AZ. Refer to BODY EQUIPMENT - TIGHTENING TORQUES .
Disconnect plug connection (1).
Remove angle transmitter (2) with retaining bracket (3).
(4) Right rear lid hinge
installation:
Angle transmitter (2) is initialized by automatic closing and opening once.