51 32 170 Removing And Installing / Replacing Door Window Glass, Front Left Or Right

Necessary Preliminary Tasks: 

• Open door window to 140 mm.
• Remove function carrier in front door, refer to 51 21 035 REMOVING AND INSTALLING/REPLACING FUNCTION CARRIER ON LEFT OR RIGHT FRONT DOOR 
• Remove outer window cavity cover strip, refer to 51 21 302 REMOVING AND INSTALLING/REPLACING CHROME STRIP FOR WINDOW CAVITY COVER STRIP (ON OUTSIDE OF FRONT DOOR) 

Door window glass must be opened to dimension (A).

A = Approx. 140 Mm

Unfasten screws (1).

Installation: 

Tightening Torque 51 32 2Az. Refer To Body Equipment - Tightening Torques .

Rubber (2) is only fitted at rear.

Turn door window glass and lift out towards rear/top.

Installation: 

Bores (1) of door window glass (5) must not be damaged.

If necessary, install new screws (2), washers (3) and plastic washers (4).

Adjust door window glass. Refer to 51 32 154 ADJUSTING LEFT OR RIGHT FRONT DOOR WINDOW GLASS .