00 00... Front and rear brake linings: checking lining thickness with measuring gauge. If linings are replaced: cleaning brake shafts, checking brake disk thickness and surface, applying grease to wheel centering on alloy wheels. If rear linings are replaced: checking parking brake linings
Check brake lining thicknesses with measuring gauge at front and rear. For subsequent procedure, refer to DISC - M3, 325I, 325CI, 325XI, 330I, 330CI and .
NOTE:
Issue a separate invoice for replacing the brake linings.
Remove front and (if necessary) rear disk brake linings. For further information on how to proceed, refer to DISC - M3, 325I, 325CI, 325XI, 330I, 330CI and .
- Removing and installing front disk brake linings. See BRAKE DISC
- Removing and installing rear disk brake linings.BRAKE DISC
NOTE:
- Clean brake shafts.
- Replace brake linings if they drop below minimum thickness (refer to TECHNICAL DATA ).
- Replace brake disks if they drop below minimum thickness (refer to TECHNICAL DATA ) and in event of scoring, heat cracks, lateral runout or thickness difference.
- Apply a thin coat of grease to wheel centering on light alloy wheels.
Additional tasks when changing rear linings
Remove rear brake disks. For subsequent procedure, refer to DISC - M3, 325I, 325CI, 325XI, 330I, 330CI and for removing and installing rear brake disks.
NOTE:
- Check parking brake lining for porosity and wear.
- Check expansion lever for ease of movement.