51 71 412 Removing and installing rear spoiler

WARNING: This page is about a different variant/trim than selected.

Lever out covers (1) on left/right and release screw underneath.

Release screws (2) on left/right and screw (3).

Remove rear spoiler and set down on a clean surface.

Fig 1: Levering Out Covers

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, make a note of number of shims on screws (2) and (3) and refit them during installation at same position.

Tighten screw (3) first.

Tightening torque, (3 N.m.).

Installation:

Threads (1) on rear spoiler (3) must not be damaged.

If necessary, replace faulty tapes (2) (dual-lock tape).

Fig 2: Installing Rear Spoiler

Courtesy of BMW OF NORTH AMERICA, INC.