65 52 023 Replacing panel for on-board monitor (control panel, widescreen)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). Refer to 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary Preliminary Tasks:

Release screws (1).

Remove upper housing section (2) in direction of arrow.

Fig 1: Removing Upper Housing Section Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Raise locks (1) in direction of arrow.

Detach ribbon cables (2) and feed out at catches (3).

Fig 2: Detaching Ribbon Cables

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure ribbon cables are correctly seated.

NOTE: Carefully feed out ribbon cables when removing panel for onboard monitor (control panel).

Release screws (1).

Remove panel for on-board monitor (control panel) in direction of arrow.

Fig 3: Removing Panel For Onboard Monitor

Courtesy of BMW OF NORTH AMERICA, INC.