51 16 ... Removing and installing/replacing center armrest sliding unit: Replacement:

Remove armrest from cover on center armrest.

Fig 1: Removing Armrest From Cover On Center Armrest

Courtesy of BMW OF NORTH AMERICA, INC.

Version with eject box:

If necessary, detach plug connection (1) with holder from center armrest (2).

Fig 2: Disconnecting Plug Connection For Eject Box

Courtesy of BMW OF NORTH AMERICA, INC.

Remove both springs (1) on left/right from center armrest (2).

Installation:

Ensure ends of springs are in correct position.

Fig 3: Removing Both Springs On Left/Right From Center Armrest

Courtesy of BMW OF NORTH AMERICA, INC.

Raise center armrest and drive out split pin (1) on left/right from inside outwards.

Installation:

Fit split pin (1) with notch facing outwards in hinge (2).

Fig 4: Fitting Split Pin With Notch Facing Outwards In Hinge

Courtesy of BMW OF NORTH AMERICA, INC.

Pull swivel arms (1) forwards.

Lever out trim(s) (2) and feed cable (3) out of swivel arms (1).

Fig 5: Pulling Swivel Arms Forwards

Courtesy of BMW OF NORTH AMERICA, INC.

Remove center armrest (1) from storage tray (2).

Remove armrest from cover on center armrest.

Fig 1: Removing Armrest From Cover On Center Armrest

Courtesy of BMW OF NORTH AMERICA, INC.