67 31 521 Removing and installing/replacing drive for seat height adjustment (front seat removed)

Disconnect connector (2).

NOTE: Secure drive for seat height adjustment (3) against falling out.

Loosen screws (1).

Remove drive for seat height adjustment (3) with fixture for plug connection (4) in direction of arrow from flange (5).

If necessary, remove inner drive shaft from drive for seat height adjustment (3).

Fig 1: Removing Seat Height Adjustment Drive

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure drive shaft (1) is correctly seated.

Ensure fixture for plug connection (2) and drive for seat height adjustment (3) on flange (4) are correctly seated.

Fig 2: Installing Seat Height Adjustment Drive

Courtesy of BMW OF NORTH AMERICA, INC.