LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2002 >> X5 30i, Automatic >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Wheel Carrier >> Removal & Installation (Coil Springs)

Removal & Installation (Coil Springs)

  1. Remove integral link. See INTEGRAL LINK .
  2. Remove wheel.
  3. Unscrew collar nut. See Figure.
  4. Press out axle shaft with special tool (33 2 111/116/117) with 5 wheel studs (1). Grip with tire iron (2) in so doing. See Figure.
  5. Lightly oil axle shaft splines and insert into drive flange splines. Screw special tool (33 2 118) onto axle shaft. Screw on special tool (33 2 116) with 5 wheel studs (1). Install axle shaft with special tool (33 2 115). See Figure.
  6. Replace collar nut and tighten to specification. See TORQUE SPECIFICATIONS . Secure collar nut by calking it at flat area of shaft. See Figure.
  7. Install integral link. See INTEGRAL LINK .
scientia non olet · About LEMON Manuals