61 61 100 Removing and installing/replacing both windshield wiper arms

NOTE:

For Special Tool identification, see SPECIAL TOOLS - X-5 (3.0i) .

Special Tools Required:

Remove cover (1).

Fig 1: Removing Cover On Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nut (1).

Installation:

Tighten nut to appropriate torque, (30 N.m).

After waiting 15 minutes, retighten nut to appropriate torque, (30 N.m).

Fig 2: Removing/Installing Nut

Courtesy of BMW OF NORTH AMERICA, INC.

CAUTION: Do not bend wiper arm during removal (risk of breakage).

Detach windshield wiper arm with special tool 61 6 060.

Replacement:

Remove wiper blade.

Fig 3: Detaching Windshield Wiper Arm With Wiper Arm Puller

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Adjust position of wiper arm in question in rest position (measured between wiper lip and top edge of cowl panel cover).

Then tighten down wiper arm and check position of relevant wiper arm again.

54+/-3 mm.
55+/-3 mm.

Fig 4: Identifying Adjustment Measurements Of Wiper Arms
Courtesy of BMW OF NORTH AMERICA, INC.