61 62 060 Removing and installing / replacing rear window wiper motor
Remove panel for rear lid upper section at bottom. Refer to 51 49 050 REMOVING AND INSTALLING/REPLACING LOWER TRIM FOR REAR LID UPPER SECTION .
Remove wiper arm for rear wiper. Refer to 61 62 030 REPLACING WIPER ARM FOR REAR WINDOW WIPER .
NOTE:
Secure rear window wiper motor against falling out.
Disconnect plug connection (1) and release screws (2).
Remove rear window wiper motor (3).
Installation:
Insert screws (2) and tighten until hand-tight.
Center rear window wiper motor (3) and tighten down screws (2).
Observe tightening torque, (10 N.m).
Installation:
Replace rubber grommet (1).
Note installation position of rubber grommet (1) (marking must be in horizontal position).