17 11 370 Removing and installing/replacing cooling loop for power steering
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Make sure all parts are absolutely clean.
No dirt is allowed to enter the system.
After installation, bleed power steering.
No dirt is allowed to enter the system.
After installation, bleed power steering.
Recycling: Draw off power steering fluid from supply tank - do not reuse fluid. Observe country-specific waste-disposal regulations.
Disconnect quick-release couplings on hydraulic lines.
Remove radiator. Refer to 17 11 000 REMOVING AND INSTALLING RADIATOR (M62, M54 AND M57) .
Remove cooling coil.