12 14 526 Replacing pulse generator on right inlet camshaft (M62)

WARNING: This page is about a different variant/trim than selected.

Interrogate fault memory of DME control unit.

Switch off ignition.

Disconnect plug connection (3) on right cable strip.

Fig 1: Disconnecting Pulse Generator Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw.

Remove pulse generator.

Fig 2: Removing Pulse Generator

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check sealing ring for damage, replace if necessary. Coat sealing ring with anti-friction rubber coating (e.g. petroleum jelly).

NOTE: Interrogate fault memory of DME control unit.
Check stored fault messages.
Rectify faults.
Now clear the fault memory.