Front and rear brake linings: Notes
WARNING: This page is about a different variant/trim than selected.
Checking lining thickness with measuring gauge. If linings are replaced: cleaning brake shafts, checking brake disk thickness and surface, applying grease to wheel centering on alloy wheels. If rear linings are replaced: checking parking brake linings
Check brake lining thicknesses with measuring gauge at front and rear. For subsequent procedure, refer to DISC - X5 .
Checking brake lining thickness.
NOTE:
Issue a separate invoice for replacing the brake linings.
Remove front and (if necessary) rear disk brake linings. For further information on how to proceed, refer to
- Removing and installing front disk brake linings.
- Removing and installing rear disk brake linings.
NOTE:
- Clean brake shafts.
- Replace brake linings if they drop below minimum thickness.
- Replace brake disks if they drop below minimum thickness, or in the event of scoring, heat cracks, lateral runout or thickness difference.
- Apply a thin coat of grease to wheel centering on light alloy wheels.