64 12 Additional Heater with Controls
WARNING: This page is about a different variant/trim than selected.
64 12 ADDITIONAL HEATER WITH CONTROLS TIGHTENING SPECIFICATION
| Type | thread | tightening specification | Dimension | |
|---|---|---|---|---|
| 1AZ Additional heater to body floor | All | 4.5 N.m | ||
| 2AZ Glow plug | E24 | 17.5 N.m | ||
| E31 / E32 / E34 | 4 N.m | |||
| 3AZ Temperature sensor | E31 / E32 / E34 | 0.5 N.m | ||
| 4AZ Oil control plug and oil filler plug | All | 16 N.m | ||
| 5AZ Mounting screws | All | M5 | 6 N.m | |
| All | M6 | 10 N.m | ||
| All | M8 | 24 N.m | ||
| All | M10 | 48 N.m | ||
| 6AZ Screws for filter cover | All | 0.9 N.m | ||
| 7AZ Central cover on heater | All | 1.5 N.m | ||
| 8AZ Combustion air fan unit on heater | All | 1.5 N.m | ||
| 9AZ Recirculating pump on heater | All | 1.5 N.m | ||
| 10AZ Control unit/transfers heat to heater Install screws with Loctite 243 |
All | 4.5 N.m |