11 13 Oil Pan
WARNING: This page is about a different variant/trim than selected.
11 13 Oil Pan Fastener Tightening Specification
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Oil drain plug | M12x1.5 | 25 N.m | ||
| M18x1.5 | 35 N.m | |||
| M22x1.5 | 60 N.m | |||
| 2AZ Oil pan on engine block | M6 8.8 | 10 N.m | ||
| M6 10.9 | 12 N.m | |||
| N40 / N42 / N45 / N46 | M8 8.8 | Replace screws | 30 N.m | |
| M8 8.8 | 22 N.m | |||
| Oil sump, lower section to upper section | M6 8.8 | 10 N.m | ||
| N62TU | M8 | 24 N.m | ||
| M8 8.8 | 22 N.m | |||
| Oil sump bottom section to top section with microencapsulated screws | M6 10.9 | Replace screws | 12 N.m | |
| Oil sump upper section to crankcase | N62TU | M6 | 10 N.m | |
| N62TU | M8 | 20 N.m |