LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2002 >> X5 30i, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> PEDALS - REPAIR - X5 (3.0i) >> Pedal Mounting Block >> 35 11 000 Removing and installing mounting block for pedals

35 11 000 Removing and installing mounting block for pedals

Remove trim for instrument panel at bottom left. Refer to 51 45 180 REMOVING AND INSTALLING TRIM FOR INSTRUMENT PANEL, BOTTOM LEFT .

Remove trim for pedals. Refer to 51 45 185 REMOVING AND INSTALLING/REPLACING TRIM FOR PEDAL ASSEMBLY .

Release screws (1).

Fig 1: Removing Pedals Mounting Block Screws
G03255528Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and press clips (2) out of light switch.

Fig 2: Removing Clips Out Of Light Switch
G03255529Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and remove reinforcement plate.

Fig 3: Removing Reinforcement Plate
G03255530Courtesy of BMW OF NORTH AMERICA, INC.

Vehicles With Manual Transmissions: 

Remove clutch switch. Refer to 61 31 295 REPLACING CLUTCH SWITCH FOR CRUISE CONTROL SYSTEM .

Remove retainer (1) and press out retaining pin.

CAUTION: Do not detach pressure line from master cylinder.

Release screws (2) and set clutch master cylinder down in footwell.

Fig 4: Removing Master Cylinder
G03255531Courtesy of BMW OF NORTH AMERICA, INC.

Raise lug of retainer (1) and detach retainer. Pull out retaining pin.

Disconnect plug from brake light switch.

CAUTION: After installation: Adjust brake light switch. 61 31 310 REPLACING BRAKE LIGHT SWITCH .

Release screws (2) and remove mounting block.

Fig 5: Removing Mounting Block And Retainer
G03255532Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Replace self-locking nuts.

Tightening torque, (26 N.m.).

scientia non olet · About LEMON Manuals