35 21 000 Removing and installing/replacing brake pedal
Remove lower right trim from instrument panel. Refer to 51 45 180 REMOVING AND INSTALLING TRIM FOR INSTRUMENT PANEL, BOTTOM LEFT .
If necessary, remove panel for pedal assembly. Refer to 51 45 185 REMOVING AND INSTALLING/REPLACING TRIM FOR PEDAL ASSEMBLY .
If necessary, remove reinforcement plate and switch unit. Refer to CLUTCH MASTER CYLINDER .
NOTE:
After installation: Adjust brake light switch.
Raise lugs on retainers (1) and detach retainers. Unhook spring (2).
Pull out retaining pin (1) and detach piston rod from brake pedal.
Remove brake pedal (2).
Installation:
Check bearing bushes (1) and replace if necessary.
Apply a light coat of grease to bearing bushes (1) and bore, refer to BMW SERVICE OPERATING FLUIDS .