51 21 200 Removing and installing/replacing outside handle and lock actuator from left or right front door

Remove sound insulation on front door, refer to 51 48 ... REMOVING AND INSTALLING/REPLACING SOUND INSULATION IN FRONT DOOR, LEFT OR RIGHT .

Remove outside handle on front door, refer to 51 21 170 REMOVING AND INSTALLING OR REPLACING OUTSIDE HANDLE FROM LEFT OR RIGHT FRONT DOOR .

Remove seals (1) and (2) for outside handle.

Fig 1: Removing Outside Handle Seals

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip ball head (1).

Fig 2: Unclipping Ball Head

Courtesy of BMW OF NORTH AMERICA, INC.

Detach Bowden cable (2) from support (3) on door lock.

Loosen bolt (1).

Fig 3: Loosening Lock Actuator Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Lift out lock actuator (2) towards front and remove to inner door panel.

Installation:

Guide (3) must be located outside metal edge (4).

Lock actuator (5) must be flush with guide (6).

CAUTION: Bowden cable (1) must not be removed or replaced.
In event of a mix-up, the door will not be able to be opened.
Lock actuator (2) has a red marking on Bowden cable (1).

Fig 4: Identifying Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Bowden cable (1) must be fitted correctly with lock actuator (2).

Fig 5: Fitting Lock Actuator

Courtesy of BMW OF NORTH AMERICA, INC.

Seal (3) must be fitted - wind noises.

Buffers (4) must be fitted.

If necessary, replace screw (1) on lock actuator (2).

Fig 6: Installing Lock Actuator

Courtesy of BMW OF NORTH AMERICA, INC.

Guide (3) must be flush with support (4).