51 24 120 Removing and installing/replacing left or right lock for rear lid lower section

Release screws (1) on drive (2).

Fig 1: Removing Screws On Drive (2)

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1).

Lever out Bowden cable (2) from right lock and (3) from left lock and remove drive (4).

Fig 2: Removing Drive (4)

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip Bowden cable (1) from holders (2).

Release screws (4) and remove left or right lock (5).

Installation:

Lay Bowden cable (1) under cable (3).

Fig 3: Uncliping Bowden Cable From Holders (2)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Bowden cable (1) must engage correctly in lock (2).

Fig 4: Engaging Bowden Cable (1) In Lock (2)

Courtesy of BMW OF NORTH AMERICA, INC.