51 11 156 Removing and installing front bumper trim (up to 10/03)

Version with headlight cleaning system:

NOTE: Have a rubber plug on hand and, after detaching hose (3), seal pump outlet (4).

Detach cable tie (1) from hose (2).

Unlock hose (3), detach and seal pump outlet (4).

Fig 1: Detaching And Seal Pump Outlet

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on left/right and lift out wheel arch finishers (2) at side.

Fig 2: Releasing Screws On Left/Right And Lift Out Wheel Arch Finishers

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out finishers (1 and 2) on left/right and remove.

Version with Park Distance Control:

Disconnect plug connection on ultrasonic sensors (3) and remove finisher (2).

Fig 3: Disconnecting Plug Connection On Ultrasonic Sensors

Courtesy of BMW OF NORTH AMERICA, INC.

Raise hood lid.

Release screws (1) on left/right.

Installation:

Fig 4: Releasing Screws On Left/Right

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Version with Park Distance Control and/or front fog lamps:

If necessary, pull bumper trim (2) forward a little and disconnect plug connections on ultrasonic sensors (3) and fog lamps (4).

Pull off bumper trim (2) and set down on a clean surface.

Fig 5: Removing Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty retainers (1) in carrier (2).

Fig 6: Replacing Faulty Retainers

Courtesy of BMW OF NORTH AMERICA, INC.