51 11 050 Removing and installing/replacing member (cross-member) for front bumper trim: Notes

Necessary preliminary tasks:

NOTE: The operation is described on the left side; proceed in the same way for the right side.

Lever lower trim (3) out of guide (1).

Unlock catches (2) and remove trim (3) in direction of arrow.

Fig 1: Unlocking Catches And Removing Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Release cable ties (1).

Disconnect plug connections (2) for fanfare horns.

Fig 2: Disconnecting Plug Connections For Fanfare Horns

Courtesy of BMW OF NORTH AMERICA, INC.

Release expander rivet (1) from fan impeller (2).

Fig 3: Releasing Expander Rivet From Fan Impeller

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: For vertical adjustment, mark position of member (3).

Release screws (1).

Release nuts (2) and remove member (3) towards front.

Installation:

Fig 4: Releasing Nuts And Removing Member Towards Front

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty metal nuts (1).

Stud bolts (2) on member (3) must not be damaged.

Fig 5: Replacing Faulty Metal Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty metal nuts (1) on member (6).