51 12 000 Removing and installing complete rear bumper (HP)

Unclip cover (1) with assembly wedge (2) and unhook in direction of arrow.

Fig 1: Removing Cover With Assembly Wedge

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on left and right.

Lift out wheel arch trim (2) on left and right.

Fig 2: Lifting Out Wheel Arch Trim On Left And Right

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1) on left and right.

Installation:

Observe tightening torque, (24 N.m.).

Fig 3: Locating Nuts On Left And Right

Courtesy of BMW OF NORTH AMERICA, INC.

Open rear lids.

Version With PDC Option:

Disconnect plug connection (1) in area (2).

Fig 4: Disconnecting Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off bumper (3) slightly towards rear, feed out PDC wiring harness in area (2).

Remove bumper (3) in direction of arrow.