61 61 100 Removing and installing/replacing both windshield wiper arms
Special tools required:
- 616 060
For further information on special tools, refer to GENERAL ELECTRICAL SYSTEM - SPECIAL TOOLS - 3-Series (M54/E46) .
Take off cap.
Unfasten nut.
Installation:
- Observe tightening torque 61 61 10AZ. Refer to GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUES - 3-SERIES (E46) .
Detach windshield wiper arm with special tool 61 6 060.
Installation:
Check that sleeve (1) is firmly seated.
If sleeve (1) is loose, it must be replaced.
A sleeve (1) firmly seated in the windshield wiper arm can be reused.
Windshield wiper arm with firmly seated sleeve (1):
Return windshield wiper system to rest position. Push wiper arm (2) with firmly seated sleeve (1) onto shaft and tighten down.
Observe tightening torque 61 61 10AZ. Refer to GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUES - 3-SERIES (E46) .
Check setting of wiper arm (2).
To correct setting, replace sleeve (1).
Windshield wiper arm with new sleeve (2):
Return windshield wiper system to rest position.
Push wiper arm (1) with sleeve (2) onto shaft and tighten until hand-tight.
Set position of relevant wiper arm to rest position and then tighten down wiper arm.
Adjustment dimensions:
| Measurement 1 [mm] | Measurement 2 [mm] |
|---|---|
| 24 | 44 |
Observe tightening torque 61 61 10AZ. Refer to GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUES - 3-SERIES (E46) .