61 61 270 Removing and installing complete wiper console

Remove Windshield Cowl Cover

Remove sealing frame from engine hood.

Fig 1: Removing Sealing Frame From Engine Hood

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten clip from right and left air ducts, twist air duct and lift out.

Fig 2: Removing Air Ducts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation Instructions:

Fit air duct to end wall. Twist, then insert in underside of microfilter.

Fig 3: Installing Air Ducts To End Wall

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten clip and lift out right and left microfilter housings.

Fig 4: Removing Left And Right Microfilters

Courtesy of BMW OF NORTH AMERICA, INC.

Release all split rivets and remove cowl screen.

Fig 5: Removing Cowl Screen

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screw and remove cover.

Fig 6: Removing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The operation "Removing windshield cowl cover" ends here.

Twist all levers through approx. 90° and remove cable cover.

Fig 7: Removing Cable Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Remove connector, unfasten screws and lift out complete wiper console.

Fig 8: Removing Complete Wiper Console

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert wiper unit in body and tighten down by hand without torsional stress. Tighten down screws in illustrated sequence. See Fig 8.