51 11 701 Replacing left or right bracket for front bumper

Bumper removed, refer to 51 11 000 REMOVING AND INSTALLING COMPLETE FRONT BUMPER .

Installation:

If necessary, mark position of bracket on body.

Unfasten screws from wheel arch and remove bracket (1).

Installation: 

When exchanging bracket, adjust dimensions (A) and (B).

Dimension (B) is measured vertically downwards at distance (C) from side panel.

1. approx. 18 mm
2. approx. 32 mm
3. approx. 115 mm
   Fig 2: Adjusting Bracket

   Courtesy of BMW OF NORTH AMERICA, INC.

Ideal adjustment:

Gap (A) should be uniform down full length between bumper and aperture in body.

Dimension (A) = 5 +/- 1 mm