84 11 510 Removing and installing/replacing eject box

Remove screws (1) and (2).

Fig 1: Removing Center Armrest Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Raise center armrest.

Disconnect all plug connections and remove center armrest.

Fig 2: Removing Center Armrest

Courtesy of BMW OF NORTH AMERICA, INC.

Pull sliding carriage apart fully and release screws.

Fig 3: Releasing Sliding Carriage Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation :

Place washers (3) on outer-lying bores.

Insert centering pin (2) of carriage in bores (1).

Fig 4: Place Washers On Outer-Lying Bores & Insert Centering Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Push sliding carriage completely together and insert cable with connectors.

Fig 5: Slide Sliding Carriage Together

Courtesy of BMW OF NORTH AMERICA, INC.

Press clips apart and press eject box forwards to remove.

Fig 6: Removing Eject Box

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Clips (1) without eject box for better representation.

Fig 7: Identifying Clips On Eject Box

Courtesy of BMW OF NORTH AMERICA, INC.