41 00... Body Gap Dimensions: Convertible
WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Symmetry of the gaps between left and right sides of the vehicle has top priority.
The door gaps must not deviate between the front and rear gap by more than 1.0 mm.
Dimensions in mm
Fig 1: Front Bumper, Hood, Headlamp, Front Fender And Front Pillar Body Gap Dimensions And Measurement Points (Convertible)
Dimension (1) 0.8 ± 0.8 is reduced in the rearward direction of travel to 0 ± 0.8
Dimension (2) 1.5 ± 1.0 is reduced in the downward direction to 0 ± 1.5
Dimension (3) 0 ± 0.7 is reduced in the forward direction of travel to 2.5 ± 0.7
Fig 2: Front Fender, Front Door, Quarter Panel And Door Sill Trim Panel Body Gap Dimensions And Measurement Points (Convertible)
Dimension (1) 4.5 ± 1.3 is reduced in the rearward direction of travel to 3.8 ± 1.1
Dimensions in mm
Fig 3: Windshield Header Panel, Front Roof Shell, Rear Roof Shell Body Gap Dimensions And Measurement Points (Convertible)
Dimension (1) may have a differential from left to right of max. 1.1 mm.
Fig 4: Quarter Panel, Rear Roof Shell, Convertible Top Lid, Trunk Lid Body Gap Dimensions And Measurement Points (Convertible)
Dimension (1) may have a differential from front to rear of max. 1.1 mm.
Fig 5: Convertible Top Lid, Trunk Lid And Rear Bumper Body Gap Dimensions And Measurement Points (Convertible)
Dimension (1) may have a differential from left to right of max. 1.1 mm.