LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2002 >> 330Ci 2D Convertible, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Repair (E46) >> Removal & Installation >> Brake Booster >> Removal

Brake Booster: Removal

  1. Remove master cylinder. See MASTER CYLINDER .
  2. Remove left windshield wiper arm. 61 61 100 REMOVING AND INSTALLING/REPLACING BOTH WINDSHIELD WIPER ARMS
  3. Move hood lid into assembly position.
  4. Pull off rubber seal (1). Remove securing clamps of cowl cover (2) up to middle of windshield. Pull cover upwards and away. See Fig 1.
  5. Release screws and remove cowl cover. See Fig 2.
  6. Remove cover (1) behind booster. Remove line feed-through (2). Pull vacuum hose (3) off of brake unit. See Fig 3.
  7. Remove brake light switch. See BRAKE LIGHT SWITCH .
  8. Pull off retainer (1). Unhinge recoil spring (2). See Fig 4.
  9. Withdraw pin (3). See Fig 5.
  10. Loosen pedal assembly nuts (1) and bolts (2). See Fig 6.
  11. Pull pedal assembly slightly away front bulkhead. See 51 71 080 REMOVING AND INSTALLING/REPLACING HEATER BULKHEAD
  12. Carefully swing out brake unit and remove from bulkhead. See 51 71 080 REMOVING AND INSTALLING/REPLACING HEATER BULKHEAD
Fig 1: Removing Rubber Seal & Securing Clamps
G00103308Courtesy of BMW OF NORTH AMERICA, INC.
Fig 2: Locating Cover Screws
G00103309Courtesy of BMW OF NORTH AMERICA, INC.
Fig 3: Removing Booster Components
G00103310Courtesy of BMW OF NORTH AMERICA, INC.
Fig 4: Locating Retainer & Recoil Spring
G00103311Courtesy of BMW OF NORTH AMERICA, INC.
Fig 5: Locating Pin
G00103312Courtesy of BMW OF NORTH AMERICA, INC.
Fig 6: Locating Pedal Assembly Nuts & Bolts
G00103313Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals