52 26 005 Removing And Installing/Replacing Rear Seat (Through-Loading System)

4-door models only: 

Unclip rear seat on left/right towards top.

For op. ext. seat heating only: 

Disconnect cable.

Lift out seat.

Installation: 

1. Feed belt buckles and lap belt (1) through intended openings into correct position.
   Fig 1: Locating Belt Buckles And Lap Belt

   Courtesy of BMW OF NORTH AMERICA, INC.

2-door models only: 

Unclip rear seat on left/right towards top.

For op. ext. seat heating only: 

Disconnect cable.

Pull out seat (if necessary under armrests) towards front.

Installation: 

1. Feed belt buckles and lap belt through intended openings into correct position.
2. If necessary, make sure ISOFIX covers are correctly engaged.