61 67 040 Adjusting spray nozzles for headlight cleaning system

Special Tools Required:

NOTE: For special tools, refer to GENERAL ELECTRICAL SYSTEM - SPECIAL TOOLS - 3 SERIES (E46) .

00 9 100
64 1 020

Low-Beam Headlamp:

The spray contact point must be located in the center of the low-beam headlamp.

To adjust, slowly pull out spray nozzle fully with aid of special tool 4 1 020 and adjust spray contact point with special tool 00 9 100.

Fig 1: Adjusting Spray Contact Point With Special Tool (00 9 100) Low-Beam Headlamp

Courtesy of BMW OF NORTH AMERICA, INC.

High-Beam Headlamp:

The spray contact point must be located in the center of the high-beam headlamp.

To adjust, slowly pull out spray nozzle fully with aid of special tool 64 1 020 and adjust spray contact point with special tool 00 9 100.

Fig 2: Adjusting Spray Contact Point With Special Tool (00 9 100) High-Beam Headlamp

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: After checking the contact points, turn ignition off and on again before repeating the spray procedure. The function of the headlight cleaning system is otherwise disabled for approx. 3 minutes. Refer to function description in Diagnosis and Information System.