LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2002 >> 325Ci 2D Convertible, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Repair (E46) >> Bleeding Brake System >> Vehicles With Abs/ASC+T >> Bleed Rear-Axle Brake Circuit

Bleed Rear-Axle Brake Circuit

NOTE: Bleeding unit is connected with maximum 29 psi (2 bar) filling pressure.
NOTE: Check relevant operating instructions for each device.
  1. Connect BMW Diagnosis and Information System (DIS).
  2. Call up service function BLEEDING ABS/ASC HYDRAULICS.
  3. Connect bleeding unit to expansion tank and switch on.
  4. Connect bleeder hose with container to bleed valve on right brake caliper.
  5. Open bleed valve.
  6. Run bleeding routine with BMW Diagnosis and Information System (DIS) with bleeder valve open.
  7. After running routine, press brake pedal 5 times to stop. Clear, bubble-free brake fluid must flow out.
  8. Close bleeder valve.
  9. Repeat procedure at left rear caliper.
  10. Switch off bleeder unit and disconnect from expansion tank.
  11. Check brake fluid level.
  12. Close expansion tank. Take care of rubber gasket in lid.
scientia non olet · About LEMON Manuals