23 00 Transmission in general
TRANSMISSION FASTENER TIGHTENING TORQUE SPECIFICATIONS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 2AZ Transmission to clutch housing | All | M12 | 76 Nm | |
| 3AZ Reinforcement plate to transmission | All | M8 | 23 Nm | |
| 4AZ Oil drain plug / filler plug | All | 50 Nm | ||
| S6S 560G / S6S420G | 52 Nm | |||
| GS6-53BZ/DZ GS6-37BZ/DZ | M18x1.5 hexagon socket | 35 Nm | ||
| GS6-37BZ/DZ / GS6-17BG | M12x1.5 | 25 Nm | ||
| GS7S47BG | 40 Nm | |||
| 5AZ Transmission extension | E83 / GS6-37DZ | M10 | 46 Nm |
TRANSMISSION FASTENER TIGHTENING TORQUE SPECIFICATIONS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Transmission to engine | ||||
| Hex screws | All | M6 | 9 Nm | |
| All | M8 | 25 Nm | ||
| All | M10 | 49 Nm | ||
| All | M12 | 74 Nm | ||
| Screw with Torx head | All | M6 | 9 Nm | |
| All | M8 | 22 Nm | ||
| All | M10 | 43 Nm | ||
| All | M12 | 72 Nm | ||
| GS7S 47BG | M10x55 8.8 | 43 Nm | ||
| GS7S 47BG | M10x42 8.8 | 42 Nm | ||
| H-transmission / G-transmission | M12 | 73 Nm | ||
| Steel screws with Torx head N52 | H transmission | M8 | 19 Nm | |
| Steel screws with Torx head N52 | H transmission | M12 | 66 Nm | |
| 2AZ Transmission to N52 engine aluminium screws marked blue | H transmission | Replace screws Jointing torque and angle of rotation must be observed without fail | ||
| H transmission | M10x30 | Jointing torque | 20 Nm | |
| Torque angle | 90-110° | |||
| H transmission | M10x85 | Jointing torque | 20 Nm | |
| Torque angle | 180-200° | |||
| H transmission | M12 | Jointing torque | 34 Nm | |
| Torque angle | 90-110° |