LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2001 >> M3 2D Convertible >> Repair and Diagnosis >> Electrical >> Gauges >> Body Equipment - Repair >> Front Door Locks, Handles, Fittings >> 51 21 300 Removing And Installing Or Replacing Window Cavity Cover Strip On Outside Of Left Or Right Front Door

51 21 300 Removing And Installing Or Replacing Window Cavity Cover Strip On Outside Of Left Or Right Front Door

NOTE:

For Special Tool identification, see MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .

Special Tools Required: 

IMPORTANT: Observe procedure for using special tool 00 9 324. Refer to 51 2. ... REMOVING WINDOW CAVITY COVER STRIP WITH SPECIAL TOOL 00 9 324 AT FRONT OR REAR .
IMPORTANT: If reusing the existing window cavity cover strip (1), make sure it is not bent.

Lever out window cavity cover strip (1) with special tool 00 9 324 (starting at B-pillar).

Fig 1: Removing Window Cavity Cover Strip
G00426747Courtesy of BMW OF NORTH AMERICA, INC.

Pull window cavity cover strip (1) out of door mirror (2) in direction of arrow.

Installation: 

Coat window cavity cover strip with water before fitting.

Window cavity cover strip (1) must be flush at rear to door edge.

Fig 2: View Of Window Cavity Cover Strip
G00426748Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Seal (1) must be correctly fitted in cover strip (2).

Fig 3: Identifying Seal In Cover Strip
G00426749Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals