51 46 050 Removing and installing/replacing finisher for top of rear apron.

Open trunk lid and left/right flaps.

Release plastic nuts (1) and remove cover (2).

Fig 1: Removing Cover

Release plastic nuts (1).

Lift out covers (2) and unfasten screws.

Release expansion rivets (3).

Lift out covers (4) and release nuts.

Remove trim (5) for tail panel at top.

Fig 2: Removing Trim For Tail Panel At Top

Only replace:

Release screws (1) and remove net (2) from trim (3) for tail panel at top.

Fig 3: Removing Net From Trim For Tail Panel At Top