54 12 115 Removing and installing glass sliding/tilting sunroof lid: Installation:

Replace removed screws (microencapsulation) or install old screws with Loctite 270.

Tighten down screws with special tool 00 9 250. Tightening torque, refer to 54 12 MECHANICAL SUN ROOF COMPONENTS .

Raise glass slide/tilt sunroof lid (1) at rear until setting lever (2) can be levered out of retaining pin (3) of lid (1).

NOTE: Place glass sunroof lid on a clean base/support.

Fig 1: Raising Glass Slide/Tilt Sunroof Lid At Rear

Setting lever with retaining screw:

Release retaining screw (1) until assembly opening is free. Raise setting lever (2) and unhook from slide (3).

Fig 2: Releasing Retaining Screw

Setting lever without retaining screw:

Inspect to see whether a retaining spring is present. Press retaining spring at front downwards, raise setting lever (2) and unhook from sliding rail (3).

Install setting lever on left/right on glass sunroof lid. Retaining pin (1) must locate correctly in bore (2).

NOTE: Note designation on right (R) or left (L) setting lever.

Fig 1: Installing Setting Lever On Left/Right On Glass Sunroof Lid

Replace screws (1) (microencapsulation) or refit old screws with Loctite 270.

Raise setting lever and insert screws (1) as far as they will go (do not tighten).

Setting lever with retaining screw:

Release retaining screw (2) until assembly opening is free. Coat protruding thread with Loctite 270.

Fig 2: Releasing Retaining Screw

NOTE: Hardening of Loctite 270 takes about 30 minutes.

Setting lever with and without retaining screw:

Install glass slide/tilt sunroof lid; in so doing, hook setting lever (1) at front correctly into sliding rail (2).

Fig 3: Hooking Setting Lever (1) At Front Into Sliding Rail (2)

CAUTION: Check that glass sunroof lid is securely seated. Press glass sunroof lid at front on left/right with ball of thumb from bottom to top.

The glass sunroof lid must not be able to be raised.

Setting lever with retaining screw:

Open glass sunroof lid approx. 250 mm.

Carefully press glass sunroof lid upwards and screw in and tighten down securing screws (2) on left/right completely.

Fig 4: Tightening Down Securing Screws

Setting lever without retaining screw:

If setting levers with retaining screws (1) are fitted, do not install any retaining screws in thread (2).

Fig 5: Setting Lever Without Retaining Screw

Make sure retaining spring (1) is correctly seated.

Adjusting glass slide/tilt sunroof lid.